NOTE: The CAN Box Transceiver (A) needs to be installed near the G06 Unit  (“H” in Diagram below). 

‣ Connect the supplied Valor Wire Harness  (B) to the CAN Box Transceiver (A). 

‣ Connect the other end of the supplied  Valor Wire Harness (B) to the GeoTab  HRN-E1 Harness (“G” in Diagram below). 

‣ The GeoTab HRN-E1 Harness (G) connects to the GeoTab HRN-CD9THD  Harness (I). Connect (I) to the vehicle  where indicated. 

‣ The system communicates over the SAE  J1939 vehicle bus. 

‣ Mount the Antenna (D) close to the  Reefer Unit and away from step and  pinch points. Run the cable along existing  wiring (use Zip Ties (F) to attach) through  the kit plate and into the cab. Connect to  CAN Box (A). 

(D) 

NOTE: Turn-on Sensors (C) prior to  installation (back of unit). Sensors are  active once turned-on. 

‣ There is a Sensor (C) for each Zone, and  each Sensor is assigned to a Zone. The  Sensor for Zone One is marked as such  (Zone 1), while the Sensor for Zone Two  is unmarked. Each sensor has a unique  identifier code which is pre-programmed  into the Transceiver (A). 

‣ Install the Sensors directly onto the  Reefer Zones’ inside wall or ceiling using  either the supplied Velcro (F) or with  screws (not supplied). 

‣ The Sensors wirelessly transmit data to  the Transceiver (A) over RF 433.92 

‣ Battery life: up to 5 years 

MyGeoTab Reporting 

• Each Zone transmits temperature data  independently on changes in  

I 

VEHICLE 

POWER 

INTERRUPTER 

RESET SWITCH 

G 

(A)D 

temperature of 1 degree Celsius 

• Exceptions for over-or-under  temperature thresholds can be setup in  the GeoTab vehicle settings 

• The GeoTab report can chart  temperature data in either Celsius or  

A B 

H 

Fahrenheit 

Address: 4320 Harvester Rd., 2nd Floor, Burlington, ON, L7L 5S4, Canada | Toll-Free: 1-800-568-9188 | www.valortpms.com