Device not beeping for Driver ID reminder

Device not beeping for Driver ID reminder with Driver feedback turned On 

When an IOX-NFC is connected to a GO device, the Driver ID relay is set to 'Use driver key to control Driver ID relay' by default .

If a user manually sets this to either of the first two options, the device will not beep for Driver ID reminder.

You can check Audit logs for Send Message to see if it was recently changed to On or Off :

Go to Administration > System > Audit Logs

 Please select 'Use driver key to control Driver ID relay' from the Vehicle Edit page to resolve this issue . 

​

• Related Articles

• MyGeotab - Driver ID Relay

  Information on Driver ID Relay can be found by following below steps : Steps 1. Go to vehicles 2. Select a vehicle 3. Click on Show help beside vehicle name 4. Click on more details on top 5. Go to Driver ID Relay. This will display the information ...

• Turn Driver Feedback on for speeding over limit

  Please follow the below steps to Setup a Rule to turn Driver Feedback on If Driver is speeding over the speed limit. Steps       1. Login to Mygeotab database       2. Go to Rules and Groups       3. Click on Add Rule       4. Enter the Rule Name , ...

• Add device in Mygeotab

  Please follow the below steps to add a device in MyGeotab database. Steps Login to Mygeotab database Go to Vehicles Click on Add> Add device Enter serial number and Description Click Ok

• MyGeotab - Reactivate Archived Driver

  This article explains how to reactivate an archived driver in MyGeotab. Steps       1. Login to your Database       2. Navigate to 'Administration' > 'Users'       3. Click on 'Filter'       4. Turn on the 'Show Archived (historical)' data       5. ...

• MyGeotab - Activate Geotab Device

  This article explains how to activate a Geotab device. Procedure Once the Geotab Device is installed in a vehicle:       1. Take a vehicle in-which a Go Device is installed       2. Take it on a 10 - 15 minute trip in an area with good cellular ...